Differences

This shows you the differences between two versions of the page.

--- docs:man:starting-stopping_particular_subsystems [2008-10-20 20:34] – initial - taken from old docs grizz
+++ docs:man:starting-stopping_particular_subsystems [2008-10-20 20:46] (current) – use service glen
@@ Line 8: / Line 8: @@
-<file># /etc/rc.d/init.d/network
+<file># service network
 Usage: /etc/rc.d/init.d/network {start|stop|restart|status}
 </file>
@@ Line 16: / Line 16: @@
-| start | runs the subsystem/service |
+| start | starts the subsystem/service |
 | stop | stops the subsystem/service |
 | restart | restarts the subsystem/service. Usually this is equivalent to start and stop, but in some cases it can be different. |
@@ Line 23: / Line 23: @@
-<file>[root@pldmachine root]# /etc/rc.d/init.d/network stop
+<file>[root@pldmachine root]# service network stop
 Shutting down interface eth0.......................................[ DONE ]
 Shutting down interface eth1.......................................[ DONE ]
-[root@pldmachine root]# /etc/rc.d/init.d/network start
+[root@pldmachine root]# service network start
 Setting network parameters.........................................[ DONE ]
 Bringing up interface eth0.........................................[ DONE ]
@@ Line 40: / Line 40: @@
-<file># chkconfig:    2345 30 70>
+<file># chkconfig:    2345 30 70
 </file>
 This tells rc-scripts to run the subsystem when entering runlevels 2, 3, 4, 5 (and respectively, to stop subsystem when leaving one of these runlevels). Numbers 30 and 70 are priority levels for start/stop. See chkconfig(8) for details.