Differences

This shows you the differences between two versions of the page.

--- docs:man:installing_pld_linux_based_on_rescue_cd [2019-01-21 20:05]
arekm [Partition disk]
+++ docs:man:installing_pld_linux_based_on_rescue_cd [2019-01-21 20:15]
arekm [Kernel installation]
@@ Line 87: / Line 87: @@
 ===== Packages installation =====
+All packages are installed using **poldek** tool (it is a package manager for PLD).
 <file># rpm --root /pld --initdb
@@ Line 133: / Line 134: @@
 Note **Kernel driver in use: ata_piix** (alias scsi_hostadapter ata_piix)
+While at it, on actual installed PLD system (not needed on rescuecd), you can do the same for network card driver:
+<file>alias netdev-eth0 e1000e</file>
+(again **lspci -k** will help to choose correct one)
@@ Line 167: / Line 174: @@
 //-v// option causes geninitrd to write additional information, so you can see if proper kernel modules are being installed into initrd.
+PLD supports systemd and non-systemd installations. In case of systemd installation you need to install package
+<file>systemd</file>
+package and setup default boot kernel cmdline option in grub/lilo. Add
+<file>init=/bin/systemd systemd.unit=graphical.target</file>
@@ Line 182: / Line 198: @@
 <file>update-grub</file>
-Resulting file is saved as **/boot/grub/grub.cfg**.
+Resulting file is saved as **/boot/grub/grub.cfg**. Setting custom options for grub2 can be done in **/etc/sysconfig/grub** (then regenerate **grub.cfg** with **update-grub** command).

PLD Linux Distribution