This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
docs:man:installing_pld_linux_based_on_rescue_cd [2019-01-21 20:05] arekm [Partition disk] |
docs:man:installing_pld_linux_based_on_rescue_cd [2019-01-21 20:07] arekm [Prepare to install kernel] |
||
---|---|---|---|
Line 133: | Line 133: | ||
Note **Kernel driver in use: ata_piix** (alias scsi_hostadapter ata_piix) | Note **Kernel driver in use: ata_piix** (alias scsi_hostadapter ata_piix) | ||
+ | |||
+ | While at it, on actual installed PLD system (not needed on rescuecd), you can do the same for network card driver: | ||
+ | |||
+ | <file>alias netdev-eth0 e1000e</file> | ||
+ | |||
+ | (again **lspci -k** will help to choose correct one) | ||