User Tools
docs:man:installing_pld_linux_based_on_rescue_cd
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
docs:man:installing_pld_linux_based_on_rescue_cd [2019-01-21 20:04] arekm [Packages installation] |
docs:man:installing_pld_linux_based_on_rescue_cd [2019-01-21 20:15] arekm [Kernel installation] |
||
|---|---|---|---|
| Line 13: | Line 13: | ||
| ===== Partition disk ===== | ===== Partition disk ===== | ||
| - | Use for example ''cfdisk'' to partition your destination disk. Usually root partition (/) and swap is enough. \\ :!: Write something more here :!: | + | Use for example ''cfdisk'' to partition your destination disk. Usually root partition (/) and swap is enough. |
| + | |||
| + | \\ :!: Write something more here :!: | ||
| Line 85: | Line 87: | ||
| ===== Packages installation ===== | ===== Packages installation ===== | ||
| + | All packages are installed using **poldek** tool (it is a package manager for PLD). | ||
| <file># rpm --root /pld --initdb | <file># rpm --root /pld --initdb | ||
| Line 131: | Line 134: | ||
| Note **Kernel driver in use: ata_piix** (alias scsi_hostadapter ata_piix) | Note **Kernel driver in use: ata_piix** (alias scsi_hostadapter ata_piix) | ||
| + | |||
| + | While at it, on actual installed PLD system (not needed on rescuecd), you can do the same for network card driver: | ||
| + | |||
| + | <file>alias netdev-eth0 e1000e</file> | ||
| + | |||
| + | (again **lspci -k** will help to choose correct one) | ||
| Line 165: | Line 174: | ||
| //-v// option causes geninitrd to write additional information, so you can see if proper kernel modules are being installed into initrd. | //-v// option causes geninitrd to write additional information, so you can see if proper kernel modules are being installed into initrd. | ||
| + | |||
| + | |||
| + | PLD supports systemd and non-systemd installations. In case of systemd installation you need to install package | ||
| + | |||
| + | <file>systemd</file> | ||
| + | |||
| + | package and setup default boot kernel cmdline option in grub/lilo. Add | ||
| + | |||
| + | <file>init=/bin/systemd systemd.unit=graphical.target</file> | ||
| Line 180: | Line 198: | ||
| <file>update-grub</file> | <file>update-grub</file> | ||
| - | Resulting file is saved as **/boot/grub/grub.cfg**. | + | Resulting file is saved as **/boot/grub/grub.cfg**. Setting custom options for grub2 can be done in **/etc/sysconfig/grub** (then regenerate **grub.cfg** with **update-grub** command). |
docs/man/installing_pld_linux_based_on_rescue_cd.txt · Last modified: 2019-01-21 20:21 by arekm
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: Public Domain
